Extron electronic Extron Electronics Switch 50 Manuel d'utilisateur Page 65
- Page / 74
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
B-7Matrix 50 Series Switchers • Reference Information
Figure B-6 — Mounting the audio board
Ensure that tools and hands are outside the switcher before powering up
the switcher.
7. If not already done, attach the power cord to the switcher and to the AC
power source. Make sure the switcher is working properly. Unplug the AC
power cord.
If, on power up, the switcher’s Power LED blinks four times, pauses, and
blinks four times again, there is a conflict in the jumper settings. Remove the
power cable, recheck the jumper settings, and power the switcher up again.
8. If not already done, reinstall the switcher’s top cover. See Closing the switcher
on page B-3.
9. If not already done, and if the switcher was removed from a rack, reinstall the
switcher in the rack.
10. If not already done, reconnect the AC power, input, and output cables.
Removing an audio module
1. Remove the bus ribbon cable and all video modules in accordance with
Removing a video module on page B-5.
2. Remove the five screws securing the audio module to the floor of the switcher
and lift the audio module out of the switcher.
3. Reinstall all video modules and the bus ribbon cable in accordance with
Installing a video module on page B-4.
4. If the size of the matrix was changed (8 x 4 configuration to 12 x 8
configuration, for example) or if video or audio capabilities were added or
removed, see Setting the front panel jumper, on page B-10.
Ensure that tools and hands are outside the switcher before powering up
the switcher.
5. If not already done, attach the power cord to the switcher and to the AC
power source. Make sure the switcher is working properly. Unplug the AC
power cord.
If, on power-up, the switcher’s Power LED blinks four times, pauses, and
blinks four times again, there is a conflict in the jumper settings. Remove the
power cable, recheck the jumper settings, and power the switcher up again.
6. If not already done, reinstall the switcher’s top cover. See Closing the switcher
on page B-3.
7. If no replacement audio module was installed, reinstall the audio cover strip
by inserting the slot on the cover strip into the tab on the right of the switcher
and tightening the screw into the switcher on the left side of the cover strip.
8. If not already done, and if the switcher was removed from a rack, reinstall the
switcher in the rack.
- Matrix 50 Series 1
- Precautions 2
- Definitions 3
- Front Panel Controls 4
- Table of Contents 5
- Table of Contents, cont’d 6
- Chapter One 9
- Introduction 10
- Features 11
- Introduction, cont’d 12
- Chapter Two 15
- Installation 16
- Composite 17
- Installation, cont’d 18
- External sync connection 19
- Chapter Three 21
- Operation 22
- I/O controls 23
- Operation, cont’d 24
- Hold Hold 31
- Troubleshooting 35
- Worksheets 35
- Preset # Title: Video: Audio: 37
- Configuration worksheet 39
- Chapter Four 41
- Programmer’s Guide 42
- Switcher Error Responses 43
- Programmer’s Guide, cont’d 44
- . Rpr10 Recalls the preset 45
- Chapter Five 47
- Matrix Software 48
- Windows buttons 49
- Matrix Software, cont’d 50
- Button-Label Generator 51
- Appendix A 53
- Specifications 54
- Audio input 55
- Audio output 55
- Control/remote 55
- Specifications, cont’d 56
- Optional Accessories 57
- Appendix B 59
- Reference Information 60
- Closing the switcher 61
- Ribbon cable 62
- Connector 62
- Self-latching receptacle 62
- Reference Information, cont’d 64
- Removing an audio module 65
- Pin 1 mark Pin 1 mark 67
- Button Labels 69
- FCC Class A Notice 73
- Extron’s Warranty 73
- Extron Electronics, USA 74
- Extron Electronics, Europe 74
- Extron Electronics, Asia 74
- Extron Electronics, Japan 74
Produits connexes et manuels pour Commutateurs vidéo Extron electronic Extron Electronics Switch 50
Commutateurs vidéo Extron electronic Extron Electronics Switch IR 701 Manuel d'utilisateur
(2 pages)
(2 pages)
Commutateurs vidéo Extron electronic Extron Electronics Switch 12800 Manuel d'utilisateur
(137 pages)
(137 pages)
Commutateurs vidéo Extron electronic MediaLink Controllers MLC 104 Series Manuel d'utilisateur
(2 pages)
(2 pages)
© 2020, manymanuals.fr. Tous droits réservés | 2.164 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels